- Brand: Genuine Toyota Parts
- Liquid Volume: 1 Gallons
- Package Information: Bottle
- And Vehicle Specific
- Manufacturer Warranty
- Toyota Quality Assured
- OEM, Not After Market
$35.44 Original price was: $35.44.$24.81Current price is: $24.81.

Antifreezes & Coolants
Buy ???? RecPro RV Antifreeze -50°F Protection Non-Toxic (2 Pack) ????
Antifreezes & Coolants
Buy ???? ACDelco GM Original Equipment 10-5027 Dex-Cool 50/50 Pre-Mix Engine Coolant – 1 Gal ✨
Antifreezes & Coolants
Budget ???? RV & Marine Splash 619526 RV/Marine Antifreeze, 6 Gal, Pink (RV/Marine Antifreeze) ????
Antifreezes & Coolants
Antifreezes & Coolants
Antifreezes & Coolants
Best reviews of ✨ Peak FXAB53 Antifreeze Coolant 50/50 1 Gal. Red ❤️
Antifreezes & Coolants
Cheapest ???? PEAK PXAB53 Antifreeze Coolant, 1 Gal, 50/50, Amber ✨
Antifreezes & Coolants
Jeremy H –
It’s DARK red and I believe to be genuine Toyota coolant. Used it in 2012 Camry SE with 4 cylinder motor. Flushed the system using 6 gallons of distilled water. Then drain. Topped off with 1 gallon of Toyota antifreeze and more distilled water. Makes a 53/47 mix.Directions for 2012 Toyota Camry SE with 4 cylinder engineTools needed: Small pliers, 1 gallon of Toyota Antifreeze, 7 Gallons of Distilled water, catch pan and 4 feet of rubber hose around 1/8 inch inside diameter or similar. (Optional: 10mm socket and ratchet to remove plastic air dam under radiator. I didn’t do this, but some find it easier to reach the radiator drain valve)1) On COLD engine, remove radiator cap and set it to the side (you won’t need it again until the end of project) Then open the drain valve on the bottom of radiator using pliers.2) Let the radiator drain out.3) Close the drain valve finger tight.4) Fill radiator with Distilled Water.5) With Radiator cap off, start engine and run until warm, paying attention to adding more distilled water as the air escapes and the water level drops. Be sure to turn on the heater, so water can circulate through the whole system. If you see foam, don’t worry about it. It may take 20-30 minutes to get the engine completely warm. Shut engine off.6) Get under car and open the drain valve on the bottom of radiator. Be careful not to get splashed as it will be hot.7) After it stops draining, close the drain valve and fill with distilled water doing step 5 & 6 all over again until you’ve used 6 of the 7 gallons of distilled water. (Note: You will only need to run the car 10-15 minutes because it will be warm thus circulating the water throughout the system giving a good dilution of the old coolant. I periodically got the RPMs to 2,000 to help circulate the water)8) After you’ve used the 6 gallons and the radiator is EMPTY, close the drain valve for the last time using pliers. DON’T over tighten the drain valve! It only needs to be finger tight, then just a slight snug with the pliers. It seriously takes very little tightening, so not the split the plastic drain port. Snug it!9) Remove plastic cap on the radiator overflow reservoir. Using the 1/8 inch rubber hose, siphon the plastic clear overflow reservoir empty. Then make note of the “L” & “F” mark on the overflow reservoir. Fill the overflow half way to the “F” mark with distilled water. Then the rest of the way to “F” mark with Toyota Antifreeze. It doesn’t need to be perfect as it will mix with whats in the radiator after a few drives.10) Fill the radiator using the remaining Toyota Antifreeze. Start engine and top off with distilled water. Put radiator cap on making sure it’s all the way on. That’s important. Some people will get it crooked, so make sure it’s on right.11) Drive the car around the neighborhood 15-20 minutes. Park the car allowing it to completely cool overnight. The next day check the coolant overflow reservoir. Remember the “L” & “F” marks? Fill it the “F” with distilled water only. Drive the car throughout the day as normal. Check the overflow reservoir the next morning and fill as needed.TIP: My driveway isn’t level. It has a slight grade so I positioned the car down hill throughout the whole process of flushing. On the final fill using the Toyota Antifreeze, I re-positioned the car facing uphill to help rid the system of air. I feel this really helped the process.
paul –
Save some money with this concentrate and distilled water for your toyota.
Larry –
I plan to get 32 years or so from our 2008 corolla. Oem matters, and dont listen to anybody who tells you the green is fine,
SuperTurboExtraGnarly –
I use this for radiator flush/refills at a 1:1 ratio with distilled water on a 1st gen Tacoma every 25-100k, depending how much motivation I have for working on the Mighty Yota.Always used the Toyata coolant. My 5VZ-FE has over 300K and has never had any cooling issues, and the interior of it’s ports/hoses look good with no residues or buildup.
Mike S. –
Great value.
neurex –
It can get con fusing not all Toyota cars use the same Anti freeze so check the manual
valentina –
El producto es excelente y llego a tiempo
Mario M. –
Don’t put anything in your Toyota except this. Formulated by Toyota for their cars. You will need to mix 50/50 with distilled water.