Outlet ???? 6240951 Thma Eng Flush Kit Omc ????

8 reviews for Outlet ???? 6240951 Thma Eng Flush Kit Omc ????

1. 

   Rated 5 out of 5

   James Hodges – July 3, 2019

   Perfect fit, not even noticeable but very functional. A must have.

2. 

   Rated 4 out of 5

   CO364 – November 26, 2019

   I tried to use it on the flush port on the front of my motor. This seems to be designed for motors that need a tell tale (pisser) so there is a hole in the adapter itself that discharges a stream of water into the motor well of my boat. I had to epoxy a small screw into the hole and it works fine now.

3. 

   Rated 5 out of 5

   Phil – February 14, 2020

   good quality very good priced

4. 

   Rated 4 out of 5

   Christopher Kendel – June 22, 2020

   This product was so bad it was like someone was playing a practical joke on me. I installed this on a brand new Suzuki DF90 A.1: The slide valve has a small hole that was above where the o ring could seal so it just sprayed water through the hole when the engine was running.2: The quick connect check valve was installed backwards preventing water from the hose to enter the engine. When I reversed the check valve it allowed water through but when connected to the stem on the slide valve, the stem was too long and prevented incoming water to open the check valve in the quick connect.Solution: I had to JB weld the small hole on the slide valve and buy a Gardena quick connect that fit the slide valve properly. The picture on the ad actually shows a orange Gardena fitting but that is not what you get. I contacted the seller and they never got back to me. Stay far away unless you have a serious sense of humor.

5. 

   Rated 5 out of 5

   Joe Smith – June 11, 2021

   Works well on engines with same size indicator hole on flush garden hose port.These four actions are critical for your engine’s cooling system and must be right:(1) If engine has no indicator hole, insert a thru-screw slathered with epoxy to seal the item’s hole.(2) Make sure holes are same diameter, if engine’s is larger, expand item’s hole to get correct back-pressure.(3) If engine’s hole is smaller, send item back and avoid insufficient back-pressure.(4) If you can’t get a watertight seal, send item back and avoid insufficient back-pressure.Always use teflon tape for watertight thread seal as with most water nylon fittings.Replace o-ring and/or apply water grease to o-ring as a last resort if the above checklist is followed but it still leaks.

6. 

   Rated 5 out of 5

   R. Hineman – October 30, 2021

   Makes flush out easier. Cheaply made. Sticks out from motor a awful long way,but should be ok as long as it isn’t hit and broke off.

7. 

   Rated 5 out of 5

   Steve Palmatier – January 4, 2022

   Works perfect on my 2020 suzuki outboard

8. 

   Rated 5 out of 5

   Cliff Trudeau – August 11, 2022

   I’ve had I less than 60 days . and it broke all ready. Not happy will not buy again.